Engineering, 16.11.2019 06:31 sethhdoty

A20,000-liter storage tank was taken out of service to repair and reattach a feed line damaged in a collision with a tanker. the tank was drained and then opened several days later for a welder to enter and perform the required work. no one realized, however, that 5 liters of liquid nonane (c9h20) remained in a collection sump at the bottom of the tank after the draining had been completed.

(a)

nonane has a lower explosive limit of 0.80 mole% and an upper explosive limit of 2.9 mole%8 (i. e., nonane-air mixtures at 1 atm can explode when exposed to a spark or flame if the nonane mole fraction is between the two given values). assume any liquid nonane that evaporates spreads uniformly throughout the tank. is it possible for the average gas-phase composition in the tank to be within the explosive limits at any time? even when the average composition falls outside those limits, why is an explosion still a possibility?

(hint: think about that assumption.)

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

You know the right answer?

A20,000-liter storage tank was taken out of service to repair and reattach a feed line damaged in a...

Questions