Engineering, 18.11.2019 21:31 jarteria0

Aerobic pond is used as a secondary wastewater treatment operation for small communities. the pond is usually shallow enough so that it can be assumed as a well-mixed aerobic reactor.
the inflow rate of wastewater entering a 200m^3-aerobic pond is 50 m^3/d and has a substrate (so) concentration of 95 mg bod5/l.
the microbe concentration (xo) in the influent is small and can be neglected. the microbial growth and substrate consumption in the pond can be described by the monod equations:

a) assuming the pond is in steady state, write mass balance equation for the microorganism concentration (x) and solve the equation to derive an expression for the substrate (s) concentration as a function of the hydraulic detention time. calculate s using the equation you derived. (ks=60 mgbod5/l, y=0.6 mg vss/mg bod5, k_d=0.06 day-1, mu_m=3 day-1)

b) write the mass balance equation for the substrate in the pond and solve it for the microbe concentration (x) as a function of the substrate concentration and hydraulic detention time. calculate x using the equation you derived.

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

You know the right answer?

Aerobic pond is used as a secondary wastewater treatment operation for small communities. the pond i...

Questions