Engineering, 19.11.2019 02:31 Eddie997

The components of an electronic system dissipating 180 w are located in a 1-m-long horizontal duct whose
cross section is 16cm x 16 cm. the components in the duct are cooled by forced air, which enters at 27oc at a
rate of 0.65 m3/min. assuming 85 percent of the heat generated inside is transferred to air flowing through
the duct and the remaining 15 percent is lost through the outer surfaces of the duct, determine
(a) the exit temperature of air and
(b) the highest component surface temperature in the duct. (note: for the purpose of
determining the air properties, you can assume the mean bulk temperature of air is 35oc).

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The drive force for diffusion is 7 fick's first law can be used to solve the non-steady state diffusion. a)-true b)-false

Answers: 1

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

Answer

You know the right answer?

The components of an electronic system dissipating 180 w are located in a 1-m-long horizontal duct w...

Questions