Engineering, 19.11.2019 06:31 XxKaitlynnxX

Water at 25°c and 1 atm is flowing over a long flat plate with a velocity of 26 m/s. determine the distance from the leading edge of the plate where the flow becomes turbulent, and the thickness of the boundary layer at that location. the density and dynamic viscosity of water at 1 atm and 25°c are rho = 997 kg/m3 and μ = 0.891×10–3 kg/m-s. a)the distance from the leading edge of the plate where the flow becomes turbulent is 1.8cm. the thickness of the boundary layer at that location is 0.5mm. b)the distance from the leading edge of the plate where the flow becomes turbulent is 1.9cm. the thickness of the boundary layer at that location is 0.4mm. c)the distance from the leading edge of the plate where the flow becomes turbulent is 1.7cm. the thickness of the boundary layer at that location is 0.1mm. d)the distance from the leading edge of the plate where the flow becomes turbulent is 1.6cm. the thickness of the boundary layer at that location is 0.3mm.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

Apreheater involves the use of condensing steam at 100°c on the inside of a bank of tubes to heat air that enters at 1 atm and 25°c. the air moves at 5 m/s in cross flow over the tubes. each tube is 1 m long and has an outside diameter of 10 mm. what is the minimum value of nl needed to achieve an outlet temperature of t 75 c? what is the corresponding pressure drop across the tube bank?

Answers: 3

Answer

Engineering, 06.07.2019 03:10

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

Answer

Engineering, 06.07.2019 03:20

What is the strain energy stored in a solid uniformly circular shaft of length 3.0 m and diameter 120 mm when subject to pure torsion if the maximum shear stress is 40 mpa? g-80gpa

Answers: 1

Answer

Engineering, 06.07.2019 04:20

Consider the transfer function for a first-order system g(s)=12(s+7)/(s^2+2s+9) for this system determine: a) poles and zeros of the function, b) the natural frequency and damping ratio, c) the peak value achieved in response to a unit step input, d) the peak time for a unit step input, e) the steady-state system response to a unit step input

Answers: 2

Answer

You know the right answer?

Water at 25°c and 1 atm is flowing over a long flat plate with a velocity of 26 m/s. determine the d...

Questions