Engineering, 21.11.2019 18:31 jujurocks10

Consider weather conditions for which the prevailingwind blows past the penthouse tower on a tall building. the tower length in the wind direction is 10 m andthere are 10 window panels. a. calculate the average convection coefficent for the 1st, 3rd, and 10th window panels when the wind speed is 5 m/s. use a film temperature of 300k to evaluate the thermophysical properties required of the correlation. would this be a suitable value of the film temperature for ambient air temperatures in the range of -15°c ≤ t[infinity] ≤ 38°c?

b. for the 1st, 3rd, and 10th windows, on one graph, plot the variation of the average convection coefficients with wind speeds in the range of 5 ≤ u[infinity] ≤ 100 km/h. explain the major features of each curve and their relative magnitudes.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 03:10

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

You know the right answer?

Consider weather conditions for which the prevailingwind blows past the penthouse tower on a tall bu...

Questions