subject
Engineering, 25.11.2019 22:31 Nalolivares

Saturated steam at 4 bars absolute pressure with a mean velocity of 3 m/s flows through a horizontal pipe whose inner and outer diameters are 55 and 65 mm, respectively. the heat transfer coefficient for the steam flow is known to be 11,000 w/m^2·k. if the pipe is covered with a 15-mm-thick layer of 85% magnesia insulation and is exposed to atmospheric air at 25°c, determine the rate of heat transfer by free convection to the room per unit length of the pipe. if the steam is saturated at the inlet of the pipe, estimate its quality at the outlet of a pipe 110 m long. start with the assumption that 60°c, then calculate the corresponding heat-transfer coefficient and a new estimate of . do not iterate. properties of the steam are 566 kj/kg, 2727 kj/kg, 2160 kj/kg, 416 k, and 0.476 m3/kg. evaluate the properties of the 85% magnesia insulation at 310 k. obtain the nusselt number using the churchill and chu correlation for the long horizontal cylinder.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
Saturated steam at 4 bars absolute pressure with a mean velocity of 3 m/s flows through a horizontal...
Questions
question
Physics, 03.01.2020 18:31
question
History, 03.01.2020 18:31
question
Physics, 03.01.2020 18:31
Questions on the website: 13722367