subject
Engineering, 26.11.2019 00:31 nrosario33

If the initial velocity is zero, the downward velocity of the freefalling bungee jumper can be predicted with the following equation: tanh where g-9.81m/s2, and m-68.1kg, but the cd value is not known precisely, it varies ±10% around a mean value of 0.3. use the rand function to generate 1000 random uniformly distrıbuted values of cd, and then employ these values along with analytical solution to compute the resulting distribution of the velocities at find out arithmetic mean, median, mode, minimum, maximum, variance (62) and standard deviation (o) of column vector v. also, draw histogram of velocity of uniform distribution

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
If the initial velocity is zero, the downward velocity of the freefalling bungee jumper can be predi...
Questions
question
Mathematics, 02.03.2021 04:00
Questions on the website: 13722367