Engineering, 26.11.2019 20:31 Dmgirl123

To use the method of superposition to calculate a beam defection and slope.
for beams with small deflections, the assumptions for using the method of superposition apply: the deflections and slopes are linearly related to the load, and the deflections do not significantly change the original geometry of the beam.

the deflections and slopes for beams subjected to multiple loads can then be found using linear combinations of known results for individual loads.

use the two loadings below and the principle of superposition to answer the following questions.

determine the load combination a beam is subjected to the loading shown where w_a = 2 kn/m and w_b = 2.8 kn/m .

describe the loading as a linear combination of the loads in the above table.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.

Answers: 1

Answer

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

To use the method of superposition to calculate a beam defection and slope.
for beams with sm...

Questions