Engineering, 28.11.2019 00:31 Cinders13

Verify that the line integral and the surface integral of stokes' theorem are equal for the following vector field, surface s, and closed curve c. assume that c has counterclockwise orientation and s has a consistent orientation. fequalsleft angle y comma font size decreased by 6 minus x comma font size decreased by 6 7 right angle; s is the upper half of the sphere x squaredplusy squaredplusz squaredequals4 and c is the circle x squaredplusy squaredequals4 in the xy-plane. construct the line integral of stokes' theorem using the parameterization r(t)equalsleft angle 2 cosine t comma font size decreased by 6 2 sine t comma font size decreased by 6 0 right angle, for 0less than or equalstless than or equals2pi for the curve c. choose the correct answer below. a. integral from 0 to 2 pi 4 font size decreased by 6 dt b. integral from 0 to 2 pi minus 4 font size decreased by 6 dt c. integral from 0 to 2 pi 8 font size decreased by 6 dt d. integral from 0 to 2 pi minus 8 font size decreased by 6 dt

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

Answer

You know the right answer?

Verify that the line integral and the surface integral of stokes' theorem are equal for the followin...

Questions