Engineering, 28.11.2019 06:31 elizabethseoane1829
Acircular ceramic plate that can be modeled as a blackbody is being heated by an electrical heater. the plate is 30 cm in diameter and is situated in a surrounding ambient temperature of 15°c where the natural convection heat transfer coefficient is 12 w/m2·k. if the efficiency of the electrical heater to transfer heat to the plate is 80%, determine the electric power that the heater needs to keep the surface temperature of the plate at 220°c.
Answers: 3
Engineering, 04.07.2019 18:10
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Engineering, 04.07.2019 19:20
Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?
Answers: 2
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
Acircular ceramic plate that can be modeled as a blackbody is being heated by an electrical heater....
Mathematics, 19.10.2020 04:01
Mathematics, 19.10.2020 04:01
Chemistry, 19.10.2020 04:01
Mathematics, 19.10.2020 04:01
Social Studies, 19.10.2020 04:01
Health, 19.10.2020 04:01
Social Studies, 19.10.2020 04:01
Mathematics, 19.10.2020 04:01
Mathematics, 19.10.2020 04:01
Mathematics, 19.10.2020 04:01
English, 19.10.2020 04:01
Mathematics, 19.10.2020 04:01
Mathematics, 19.10.2020 04:01