Engineering, 30.11.2019 00:31 quavion61

An aircraft fuselage is 180" in diameter to the midplane of the skin, which is 0.063" thick 7075-t6 al sheet (ftu-79 ksi, e-10.5 msi). if the aircraft is pressurized each flight to a maximum differential pressure of 9.1 psi, and a factor of safety of 2.0 is required for evaluating static strength against ultimate pressure, assume the skins carry the pressure load alone (frame assistance is negligible) & determine the maximum ultimate principal stresses in the skin, and the minimum ultimate (static) margin of safety 1 . fi-26.0 ksi, f2=13.00 ksi, ms-2.04.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

An aircraft fuselage is 180" in diameter to the midplane of the skin, which is 0.063" thick 7075-t6...

Questions