Engineering, 02.12.2019 21:31 Thania3902

Asimple ideal brayton cycle operates with air with minimum and maximum tempera-tures 30◦c and 1000◦c. it is designed so that the maximum cycle pressure is 1500 kpaand the minimum cycle pressure is 100 kpa.
(a) determine the temperature, pressure and specific volume at the inlet and outlet of the compressor and the inlet and outlet of the turbine.
(b) find the heat supplied, heat rejected, work done by the system, work done on the system, net work done, back work ratio and thermal efficiency.
(c) calculate the thermal efficiency of a carnot cycle operating between the same temperature limits.
(d) calculate the change in entropy of the working fluid for (i) the combustion process, and (ii) the exhaust process.
(e) sketch the p − v and t − s diagrams.
(f) if the mass flow rate is 50kg/s, find the power output.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

You know the right answer?

Asimple ideal brayton cycle operates with air with minimum and maximum tempera-tures 30◦c and 1000◦c...

Questions