Engineering, 03.12.2019 04:31 saniyawilliams1207
Ahelical compression spring is to be made of oil-tempered wire of 4-mm diameter with a spring index of c = 10. the spring is to operate inside a hole, so buckling is not a problem and the ends can be left plain. the free length of the spring should be 80 mm. a force of 50 n should deflect the spring 15 mm. determine the spring rate. determine the minimum hole diameter for the spring to operate in. determine the total number of coils needed. determine the solid length. determine a static factor of safety based on the yielding of the spring if it is compressed to its solid length.
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
Ahelical compression spring is to be made of oil-tempered wire of 4-mm diameter with a spring index...
Questions
Geography, 25.06.2019 01:30
Social Studies, 25.06.2019 01:30
Mathematics, 25.06.2019 01:30
Geography, 25.06.2019 01:30
Mathematics, 25.06.2019 01:30
Mathematics, 25.06.2019 01:30
Mathematics, 25.06.2019 01:30
Mathematics, 25.06.2019 01:30
