subject
Engineering, 03.12.2019 18:31 aidentrooper8629

4. using the creep curves for polypropylene, estimate a) the e after 7x105 seconds. b) the length and diameter after 7x105 s of sample with an initial length of 112 mm and an initial diameter of 10.1 mm subjected to a constant force of 295 n. poisson’s ratio for this polymer is 0.36.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
question
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
4. using the creep curves for polypropylene, estimate a) the e after 7x105 seconds. b) the length an...
Questions
question
Mathematics, 20.08.2019 23:10
question
Mathematics, 20.08.2019 23:10
Questions on the website: 13722360