Engineering, 03.12.2019 19:31 kody2lewiskl

Aservomechanism position control has the plant transfer function g(s) = 10/s(s + 1)(s + 10)

you are to design a series compensation transfer function dc(s) in the unity feedback configuration to meet the following closed-loop specifications .

the response to a reference step input is to have no more than 16% overshoot. the response to a reference step input is to have a rise time of no more than 0.4 sec.

the steady -state error to a unit ramp at the reference input must be less than 0.05.

(a) design a lead compensation that will cause the system to meet the dynamic response specifications, ignoring the error requirement

(b) what is the velocity constant kv for your design? does meet the error specification?

(c) design a lag compensation to be used in series with the lead you have designed to cause the system to meet the steady-state error specification.

(d) give the matlab plot of the root locus of your final design.

(e) give the matlab response of your final design to a reference step.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

Aservomechanism position control has the plant transfer function g(s) = 10/s(s + 1)(s + 10)

Questions