Engineering, 03.12.2019 21:31 stdntlogin3206

Technician a says that carbon monoxide (co) and hydrocarbon (hc)
levels should increase if the air injection reactor (air) hoses are pinched off.
technician b says that a defective drive belt may cause air system
problems. who is correct?
a. technician a
b. both technicians a and b
c. technician b
d. neither technician a nor b
15. which of these items will least likely increase pressure in the
evaporative emission control system?
a. returned fuel from the fuel-injection system
b. inlet fuel to the fuel pump
c. fuel temperature
d. volatility of the fuel
12. as the efficiency of the catalytic converter drops through deterioration,
the switching rate of the rear o2 sensor signal will start to look like the front
o2 sensor signal. when the rear o2 sensor signal reaches approximately 75
percent of the front o2 sensor, which of the following is the result?
a. the catalyst beads in the converter should be changed.
b. the diagnostic trouble code is stored with the mil on.
c. the catalytic converter should be replaced.
d. a one-trip flag is set with a code stored, but the mil isn't activated.
7. which of these engine concerns may be caused by a stuck-open
exhaust gas recirculation (egr) valve?
a. ping (spark knock or detonation)
b. engine missing at highway speed
c. excessive nox exhaust emissions
d. rough idle/stalling

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

You know the right answer?

Technician a says that carbon monoxide (co) and hydrocarbon (hc)
levels should increase if the...

Questions