subject
Engineering, 04.12.2019 07:31 hibah2004

Acertain job shop specializes in one-of-a-kind orders dealing with parts of medium-to-high complexity. a typical part is processed sequentially through ten machines in batch sizes of one. the shop contains a total of eight conventional machine tools and operates 35 hours per week of production time. the machine tools are interchangeable in the sense that they can be set up for any operation required on any of the parts. average time values on the part are: machining time per machine = 0.5 hour, work handling time per machine = 0.3 hour, tool change time per machine = 0.2 hour, setup time per machine = 6 hours, and nonoperation time per machine = 12 hours. a new programmable machine has been purchased by the shop that is capable of performing all ten operations in a single setup. the programming of the machine for this part will require 20 hours; however, the programming can be done off-line, without tying up the machine. the setup time will be 10 hours. the total machining time will be reduced to 80% of its previous value due to advanced tool control algorithms; the work handling time will be the same as for one machine; and the total tool change time will be reduced by 50% because it will be accomplished automatically under program control. for the one machine, nonoperation time is expected to be 12 hours. (a) determine the manufacturing lead time for the traditional method and for the new method. (b) compute the plant capacity for the following alternatives: (i) a job shop containing the eight traditional machines(ii) a job shop containing two of the new programmable machines. assume the typical jobs are represented by the data given above. (c) determine the average level of work-in-process for the two alternatives in part (b), if the alternative shops operate at full capacity.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
question
Engineering, 04.07.2019 19:10
Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.
Answers: 2
question
Engineering, 04.07.2019 19:20
Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.
Answers: 2
question
Engineering, 04.07.2019 19:20
Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.
Answers: 1
You know the right answer?
Acertain job shop specializes in one-of-a-kind orders dealing with parts of medium-to-high complexit...
Questions
question
Mathematics, 17.02.2020 21:16
question
Mathematics, 17.02.2020 21:16
Questions on the website: 13722366