Engineering, 04.12.2019 23:31 maddie02294

Flue gas is cooled from 1373.15 k to 400 k and the heat is used to generate saturated steam at 100 °c in a boiler. the flue gas heat capacity is given by: cp /r = 3.83 + 0.000551t. water enters the boiler at 100 °c and is vaporized at this temperature, 100 °c. (its latent heat of vaporization is 2256.9 kj/kg).

a. with reference to the surrounding temperature of 15 °c, what is the lost work in units of kj/mol flue gas?

b. with reference to the surrounding temperature of 15 °c, what is the maximum work in kj/mol flue gas that can be accomplished by the saturated steam at 100 °c if it condenses only and does not subcool?

c. what is the maximum work theoretically obtainable from the flue gas itself as it cools from 1373.15 k to 4000 k? (the surrounding temperature at 15 °c)

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Acircular aluminum shaft mounted in a journal is shown. the symmetric clearance gap between the shaft and journal is filled with sae 10w-30 oil at t 30°c. the shaft is caused to turn by the attached mass and cord. develop and solve a differential equation for the angular speed of the shaft as a function of time.

Answers: 2

Answer

You know the right answer?

Flue gas is cooled from 1373.15 k to 400 k and the heat is used to generate saturated steam at 100 °...

Questions