Engineering, 06.12.2019 04:31 meredith48034
Pure aluminum is poured into a sand mold. the metal level in the pouring basin is 4.5 in. above the metal level in the mold, and the runner is circular with a 0.25 in diameter. the viscosity of the metal is 1.5e-07 lb-s/in2 and its density is 0.098 ib/in3 g 32.2 fsec 2
a) calculate the velocity of the metal when it gets into the mold.
b) calculate the flow rate of the metal when it gets into the mold.
c) calculate the reynolds number (re velocity*diameter*density/viscosity )
Answers: 1
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
Engineering, 06.07.2019 03:20
An air-conditioning system consists of a heating section and an evaporative cooler. air enters the heating section at 10°c and 70 percent relative humidity at a rate of 30m^3/min, and it leaves the evaporative cooler at 20°c and 60 percent relatively humidity. if the air conditioning system operates at a total pressure of 98 kpa, determine (a) the temperature and relative humidity of the air when it leaves the heating section, (b) the rate of heat transfer in the heating section, and (c) the rate of water added to air in the evaporative cooler
Answers: 2
Pure aluminum is poured into a sand mold. the metal level in the pouring basin is 4.5 in. above the...
English, 26.03.2021 19:10
Mathematics, 26.03.2021 19:10
Advanced Placement (AP), 26.03.2021 19:10
Mathematics, 26.03.2021 19:10
Mathematics, 26.03.2021 19:10
Biology, 26.03.2021 19:10
Mathematics, 26.03.2021 19:10
Mathematics, 26.03.2021 19:10
History, 26.03.2021 19:10