The extruder head in a fused-deposition modeling setup has a diameter of 1.25 mm (0.05 in.) and produces layers that are 0.25 mm (0.01 in.) thick. if the extruder head and polymer extrudate velocities are both 40 mm/s, estimate the production time for the generation of a 38-mm (1.5-in.) solid cube. assume that there is a 15-second delay after deposition of each layer as the extruder head is moved over a wire brush for cleaning. (4 points)

the warning light flashes for a second or two when the engine starts. if it stays on, there's must be something wrong with the coolant. you should never dare to continue driving when the light is on. pull over as soon as possible and shut the engine off.

hope this is what you're talking about

answer:

i dont know the answer but good luck

explanation:

answer:

truck

explanation:

its a truck maybe cause a rv is like a truck and yea but plz mark brainlest!