Engineering, 07.12.2019 02:31 orlando19882000

Anuclear power plant based on the rankine cycle operates with a boiling-water reactor to develop net cycle power of 3 mw. steam exits the reactor core at 100 bar, 52o degree c and expands through the turbine to the condenser pressure of 1 bar. saturated liquid exits the condenser and is pumped to the reactor pressure of l00 bar. isentropic efficiencies of the turbine and pump are 81% and 78%, respectively. cooling water enters the condenser at 15 degree c with a mass flow rate of 114.79 kg/s. determine (a) the thermal efficiency. (b) the temperature of the cooling water exiting the condensor in degree c.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

You know the right answer?

Anuclear power plant based on the rankine cycle operates with a boiling-water reactor to develop net...

Questions