subject
Engineering, 10.12.2019 01:31 emanuelmorales1515

Agas stream containing 40.0 mole% hydrogen, 35.0% carbon monoxide, 20.0% carbon dioxide, and 5.0% methane is cooled from 1000oc to 10oc at a constant absolute pressure of 35 atm. gas enters the cooler at 120 m3/min and, upon leaving the cooler, is fed to an absorber where it is contacted with refrigerated liquid methanol that enters the absorber at a molar flow rate 1.2 times that of the inlet gas and at -15oc. essentially all of the co2 is absorbed, as is 98% of the methane and an inconsequential amount of the other components of the feed gas. the gas leaving the absorber is saturated with methanol at -12oc and is fed to a reactor for further processing.

(a) calculate the volumetric flow rate of methanol entering the absorber (m3/min) and the molar flow rate of methanol in the gas leaving the absorber. do not assume ideal-gas behavior when doing pvt calculations.

(b) list and explain at least three hazards associated with the system described.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
The higher the astm grain size number, the finer the gran is. a)-true b)-false
Answers: 2
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
Agas stream containing 40.0 mole% hydrogen, 35.0% carbon monoxide, 20.0% carbon dioxide, and 5.0% me...
Questions
question
English, 12.01.2021 02:40
question
Mathematics, 12.01.2021 02:40
question
Biology, 12.01.2021 02:40
question
Mathematics, 12.01.2021 02:40
question
Mathematics, 12.01.2021 02:40
Questions on the website: 13722367