subject
Engineering, 10.12.2019 01:31 mariaaking1413

Consider the diffusion of a drug from a cylindrical disk. for a thin disk (thickness h< < r, where r is the radius), diffusion from the disk into the surrounding tissues can be treated as a one-dimensional problem in the direction along the axis of the disk. (a) a drug is being released uniformly from the material contained in the disk at a fixed rate (moles per unit volume per unit time). find an expression for the steady-state concentration profile of the drug inside the disk. you may assume that the drug diffuses so freely in the surrounding tissue, relative to within the disk, that the surface concentrations c(x=0) and c(x=h), can both be assumed to be zero (b) compute the steady flux (moles per unit time) of drug out of the disk at x-o and x =h.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
question
Engineering, 04.07.2019 18:10
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
You know the right answer?
Consider the diffusion of a drug from a cylindrical disk. for a thin disk (thickness h< < r,...
Questions
question
Mathematics, 18.07.2019 04:10
Questions on the website: 13722360