Engineering, 11.12.2019 19:31 ricardodeleon152
An ideal reheat rankine cycle with water as the work- ing fluid operates the boiler at 15,000 kpa, the reheater at 2000 kpa, and the condenser at 100 kpa. the temperature is 450°c at the entrance of the high-pressure and low-pressure turbines. the mass flow rate through the cycle is 1.74 kg/s. determine the power used by pumps, the power produced by the cycle, the rate of heat transfer in the reheater, and the ther- mal efficiency of this system.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 05.07.2019 10:10
What is the correct way to measure the overall length of a boat? measure from the tip of the bow to the highest point on the gunwale. measure from the tip of the bow in a straight line to the stern of the boat. measure from the tip of the bow in a straight line to the back seat. measure from port to starboard at the boat's widest point.
Answers: 1
Engineering, 06.07.2019 02:30
A75mm diameter shaft is supported in a journal bearing 75mm long with a diametral clearance of 0. 1mm. it supports a radial load of 1000 n and is lubricated with sae 50 oil at 70°c. find the friction torque and the power loss when the crankshaft rotates at 2900 rev/min.
Answers: 1
You know the right answer?
An ideal reheat rankine cycle with water as the work- ing fluid operates the boiler at 15,000 kpa, t...
Questions
Chemistry, 01.12.2020 23:30
History, 01.12.2020 23:30
Arts, 01.12.2020 23:30
Mathematics, 01.12.2020 23:30
English, 01.12.2020 23:30
Mathematics, 01.12.2020 23:30
Mathematics, 01.12.2020 23:30
English, 01.12.2020 23:30
English, 01.12.2020 23:30
History, 01.12.2020 23:30
