Engineering, 12.12.2019 01:31 anthonymw

Temperature dependence of gaas led and sio2 fabry perot cavity: instead of assuming the temperature is constant at room temperature, now, consider gaas led bandgap changes with temperature by using varshni equation. (a) plot the bandgap energy with temperature ranged from 298k to 398k (b) plot the wavelength corresponding to the bandgap energy with temperature ranging from 298k to 398k (c) plot the peak emission wavelength with temperature ranging from 298k to 398k. how much does the peak emission change? (d) compare the full-width-at-half-max linewidth for 298k, and 398k, does the linewidth broadened as temperature increases?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Oxygen at 300 kpa and 400 k is in a closed system with an initial volume of 0.1 m3. is now compressed in a polytropic process, with exponent of n 1.2, to a temperature of 500 k. calculate: a) the boundary work done during the compression, in kj b) the heat transfer during the compression, in kj

Answers: 3

Answer

Engineering, 06.07.2019 03:20

Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.

Answers: 2

Answer

Engineering, 06.07.2019 04:20

Steam enters a turbine at steady state at 2 mpa, 360°c with a velocity of 100 m/s. saturated vapor exits at 0.1 mpa and a velocity of 50 m/s. the elevation of the inlet is 3 m higher than at the exit. the mass flow rate of the steam is 15 kg/s, and the power developed is 7 mw. let g 9.81 m/s^2. determine: a)-the area at the inlet, in m^2 b)-the rate of heat transfer between the turbine and surroundings, in kw c)-draw a p-v diagram for this process.

Answers: 1

Answer

You know the right answer?

Temperature dependence of gaas led and sio2 fabry perot cavity: instead of assuming the temperature...

Questions