Engineering, 12.12.2019 04:31 succ29
An adiabatic turbine (but not isentropic) has steam enter at a pressure of 200 psia, a temperature of 500 f and a velocity of 40 ft/s. the steam leaves at 20 psia and a temperature of 300 f an da velocity of 20 ft/s. the turbine is providing 100 horespower of work. answer the questions below but be careful to answer the correct question.
1. what is the actual mass flow in lbm/s through this turbine to three significant digits?
2. what is the maximum physically possible the turbine could supple in horsepower (hp) to three significant digits?
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
You know the right answer?
An adiabatic turbine (but not isentropic) has steam enter at a pressure of 200 psia, a temperature o...
Questions
Mathematics, 29.08.2020 04:01
Arts, 29.08.2020 04:01
English, 29.08.2020 04:01
Mathematics, 29.08.2020 04:01
History, 29.08.2020 04:01
History, 29.08.2020 04:01
