Engineering, 12.12.2019 05:31 teddybear8728

Acombined power cycle relies on a gas turbine cycle and a rankine cycle. heat is fed to the gas turbine combustor at a rate of 50 mw. the gas turbine cycle operates at an efficiency of 0.35. the gas that exhausts from the turbine is still hot and is used to boil water in the rankine cycle. the rankine cycle operates at an efficiency of 0.42.

find:
a) the total power produced by the combined cycle

b) the efficiency of the combined cycle
c) the rate of heat rejection from the rankine cycle

d) if the rankine boiler is operating at a pressure of 2 mpa and the steam enters the turbine at a temperature of 300 c, what is the mass flow rate of water through the rankine engine? you may assume that the water leaving the pump is saturated liquid at 2 mpa.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Condition monitoring is a major component of. (clo4) a)- predictive maintenance. b)-preventive maintenance c)-proactive maintenance d)-reactive maintenance.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

Acombined power cycle relies on a gas turbine cycle and a rankine cycle. heat is fed to the gas turb...

Questions