Engineering, 13.12.2019 06:31 erikacastro5404

1). an electronic pid temperature controller is at steady state with an output of 10 ma. the set point equals the initial steady-state process temperature. at t = 0, the error signal is increased at the rate of 0.4 ma/min, which is equivalent to a rate of 2°f/min. if the current settings are kc = 3 (dimensionless), τi = 1.5 min, τd = 0.5 min, then (a) derive an expression for the controller output p(t) (b) repeat (a) for τd = 0 (a pi controller only) (c) plot the two controller outputs and qualitatively discuss their differences. (d) what is the transmitter calibration of ma/°f? (e) say after 1 min, the error signal went back to zero. what would p(t) be in that case?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

1). an electronic pid temperature controller is at steady state with an output of 10 ma. the set poi...

Questions