Engineering, 13.12.2019 17:31 bri2008

For the following sets of functions, design a system
i. using a rom
ii. using a pla with the number of product terms shown
iii. using a pal

a. f(a, b,c, d) = σm(1,2,6,7,8,9,12,13)
g(a, b,c, d) = σm(1,8,9,10,11,13,15)
h(a, b,c, d) = σm(1,6,7,8,11,12,14,15)

b. w(a, b, c) = σm(0, 1, 4)
x(a, b, c)= σm(0, 3, 4, 7)
y(a, b, c) = σm(l, 2, 6)
z(a, b, c)= σ(2, 3, 6, 7)

c. f(a, b, c, d)= σm(5, 6, 7, 8, 11,13, 14,15)
g(a, b, c, d)= σm(0, 1, 5, 6, 8, 9, 11,13, 14)

d. f(a, b, c)= σm(1, 2, 6, 7, 8, 9, 12, 13)
g(a, b, c, d)= σm(l, 8, 9, 10, 11, 13, 15)
h(a, b, c, d) =σm(6, 7, 8,11, 12,14, 15)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

For the following sets of functions, design a system
i. using a rom
ii. using a pla with...

Questions