subject
Engineering, 18.12.2019 04:31 kkpowell

Aroom in a building has the following characteristics: sensible heat gain: 90,000 btu/hr, latent heat gain: 40,000 btu/hr, supply air: 3,600 cfm @ 55 deg. f db

air ventilation: 700 cfm, the room is kept at 78 deg. f db and 45% rh. outdoor air is 92 deg. f db 76 deg. f wb.

what is the wet bulb wb air temperature entering eat and wb temperature of air leaving the cooling coils lat in the room?

[lat = 55 deg. f db, given, need to calculate eat db, lat wb. the eat db of the air entering the cooling coils is the mixed temperature = [(room temp db)(2,900) cfm + (outside air temp db)(700)]/3,600 cfm. find eat wb and h of eat from chart. find h of outside air from chart. then q for outside air = (4.)(cfm) where cfm is outside air ventilation = about 26,800 btu/hr (show this), then total q = (sensible heat gain) + (latent heat gain) + (outside air heat gain) = about 157,000 btu/hr (show this), then total q = (4.)(total cfm), then find (? h) from total q, then find h of leaving air from ? h, then find wb temp of leaving air lat wb from chart. we get eat = 80.7 deg. f db/66.2 deg. f wb, lat = 51.7 deg. f wb.]

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 19:20
Determine the stoichiometric and actual air-fuel ratios and the mole flue gas composition for combustion with 15% excess air for raw indiana, pennsylvania raw coal.
Answers: 3
You know the right answer?
Aroom in a building has the following characteristics: sensible heat gain: 90,000 btu/hr, latent h...
Questions
question
Mathematics, 03.02.2021 01:00
question
Mathematics, 03.02.2021 01:00
Questions on the website: 13722359