Engineering, 19.12.2019 00:31 tiarafaimealelei

The disk rolls without slipping on the horizontal surface as shown . the disk has a clockwise angular velocity of 20 rad/s and a counterclockwise angular acceleration of 5 rad/s^2 at the instant under consideration .the value of r is 200mm and the angle between ab and ob is given as 19.11degree .pin a is fixed to the disk but slides freely within the slotted member bc. determine the velocity and acceleration of pin a relative to the slotted member bc and the angular velocity and angular acceleration of bc. neglect the distance from the center of pin a to the edge of disk.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Agas mixture consists of 8 kmol of h2 and 2 kmol of n2. determine the mass of each gas and the apparent gas constant of the mixture.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.

Answers: 1

Answer

You know the right answer?

The disk rolls without slipping on the horizontal surface as shown . the disk has a clockwise angula...

Questions