Engineering, 19.12.2019 06:31 lakeshia8880

Acompression spring is needed to fit over a 0.5-in diameter rod. to allow for some clearance, the inside diameter of the spring is to be 0.6 in. to ensure a reasonable coil, use a spring index of 10. the spring is to be used in a machine by compressing it from a free length of 5 in through a stroke of 3 in to its solid length. the spring should have squared and ground ends, unpeened, and is to be made from cold-drawn wire.

(a) determine a suitable wire diameter.
(b) determine a suitable total number of coils.
(c) determine the spring constant.
(d) determine the static factor of safety when compressed to solid length.
(e) determine the fatigue factor of safety when repeatedly cycled from free length to solid length, using the gerber fatigue failure criterion with zimmerli data.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Brief discuss how the presence of dislocations in crystal structures can be an advantage and a disadvantage to engineer and designers.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

Acompression spring is needed to fit over a 0.5-in diameter rod. to allow for some clearance, the in...

Questions