Engineering, 20.12.2019 05:31 christeinberg1

Ahelical compression spring is to be cycled between 150 lbf and 300 lbf with a 1-in stroke. the number of cycles is low, so fatigue is not an issue. the coil must fit in a 2.1-in diameter hole with a 0.1-in clearance all the way around the spring. use unpeened oil tempered wire with squared and ground ends. (a) determine a suitable wire diameter, using a spring index of c 5 7. (b) determine a suitable mean coil diameter. (c) determine the necessary spring constant. (d) determine a suitable total number of coils. (e) determine the necessary free length so that if the spring were compressed to its solid length, there would be no yielding.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

Ahelical compression spring is to be cycled between 150 lbf and 300 lbf with a 1-in stroke. the numb...

Questions