Engineering, 21.12.2019 05:31 xojade
Asolid round bar with diameter of 2 in has a groove cut to a diameter of 1.8 in, with a radius of 0.1 in. the bar is not rotating. the bar is loaded with a repeated bending load that causes the bending moment at the groove to fluctuate between 0 and 25 000 lbf in. the bar is hot-rolled aisi 1095, but the groove has been machined. determine the factor of safety for fatigue based on infinite life using the modified goodman criterion, and the factor of safety for yielding.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Explain the difference laminar and turbulent flow. explain it with the shear stress and the velocity profiles.
Answers: 1
Engineering, 04.07.2019 18:10
Determine whether or not it is possible to compress air adiabatically from k to 140 kpa and 400 k. what is the entropy change during this process?
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
Asolid round bar with diameter of 2 in has a groove cut to a diameter of 1.8 in, with a radius of 0....
Questions
Mathematics, 18.03.2021 19:10
History, 18.03.2021 19:10
Chemistry, 18.03.2021 19:10
Mathematics, 18.03.2021 19:10
Biology, 18.03.2021 19:10
English, 18.03.2021 19:10
Health, 18.03.2021 19:10
English, 18.03.2021 19:10
Mathematics, 18.03.2021 19:10
Biology, 18.03.2021 19:10
Mathematics, 18.03.2021 19:10
Mathematics, 18.03.2021 19:10
