Engineering, 23.12.2019 23:31 anonymous1813
The ex. flush is used to zero out control signals in the ex/mem pipeline registers. explain the function of this ex. flush control signal (a) why is it needed? (b) what does it zero out? explain.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 19:10
The short distance from the objective lens to the object causes problems at high magnification. which of the following is the most serious? a. cleaning the object surface b. positioning the object c. reflection from the object surface. d. illumination of the object
Answers: 1
You know the right answer?
The ex. flush is used to zero out control signals in the ex/mem pipeline registers. explain the fun...
Questions
Mathematics, 03.03.2022 22:30
Mathematics, 03.03.2022 22:30
Mathematics, 03.03.2022 22:30
English, 03.03.2022 22:30
Arts, 03.03.2022 22:30
Mathematics, 03.03.2022 22:30
Social Studies, 03.03.2022 22:30
Medicine, 03.03.2022 22:30
History, 03.03.2022 22:30
Computers and Technology, 03.03.2022 22:30
Physics, 03.03.2022 22:30
