Engineering, 24.12.2019 06:31 heavenwagner
When a rear wheel drive car accelerates around a bend at high speeds, the drive shaft is subject to both bending and torsional loads. the accelerating torque is reasonably constant at 400 nm while the bending moment at a critical section varies due to cornering and can be expressed in n-m as m = 250 + 800sinωt. design the shaft for infinite life using de-goodman criterion assuming the shaft is uniform cross-section. the reliability in estimating the endurance limit should be at least 99% and a safety factor of 4.5 should be used in the design. the shaft is forged from 1080 steel of ultimate strength 620 mpa and yield strength 380 mpa.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:20
Atank with constant volume contains 2.27 kg of a mixture of water phases (liquid-vapor). in the initial state the temperature and the quality are 127 °c and 0.6, respectively. the mixture is heated until the temperature of 160 oc is reached. illustrate the process in a t-v diagram. then, determine (1) the mass of the vapor in kg at the initial state, (2) the final pressure in kpa.
Answers: 3
Engineering, 04.07.2019 19:10
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
Engineering, 04.07.2019 19:20
Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3
Answers: 2
Engineering, 04.07.2019 19:20
A5 kg block of fe is dropped into a very large vat of water. the fe and water initial temperatures are 95 and 25 c, respectively. the fe final temperature is 25 c and the water can be treated as a thermal reservoir,. treated as a thermal reservoir take the water to be the system and determine the entropy generation. report vour answer in kj/k.
Answers: 1
You know the right answer?
When a rear wheel drive car accelerates around a bend at high speeds, the drive shaft is subject to...
Questions
Computers and Technology, 03.02.2020 23:48
History, 03.02.2020 23:49
English, 03.02.2020 23:49
Mathematics, 03.02.2020 23:49
