Engineering, 20.01.2020 19:31 StephenCurry34
I"powered up" my circuit by connecting it to the live terminals of a power supply. i then measured the resistance of a resistor in my circuit and wound up with an unexpected value. i therefore concluded that the resistor was out of tolerance, so i removed it from the circuit. did i do something wrong? was the resistor really out of tolerance?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86
Answers: 2
Engineering, 04.07.2019 19:10
Ahelical coil spring has a mean diameter of 50 mm, a wire diameter of 5.5 mm and is wound with a pitch of 10 mm. the spring steel has an ultimate strength of 1250 mpa. find the force needed to compress the spring solid and the wire stress in this condition. state whether the spring will return to its initial length.
Answers: 1
Engineering, 04.07.2019 19:10
Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)
Answers: 3
You know the right answer?
I"powered up" my circuit by connecting it to the live terminals of a power supply. i then measured t...
Questions
Mathematics, 01.12.2021 02:40
Mathematics, 01.12.2021 02:40
Social Studies, 01.12.2021 02:40
English, 01.12.2021 02:40
Mathematics, 01.12.2021 02:40
Chemistry, 01.12.2021 02:40
