subject
Engineering, 22.01.2020 22:31 lizbeth696

Asealed container initially contains only 1.0 m gas a and 1.0 m gas b. upon heating the following reaction takes place: a(g) + 2 b(g) ? c(g)+ 2 d(l). after the reaction comes to equilibrium, the concentration of gas c is 0.25 m. what is the equilibrium constant kc for this reaction?

b). the decomposition of n2o4 into no2 has kp = 2. some n2o4 is placed into an empty container, and the partial pressure of no2 at equilibrium is measured to be 0.2 atm. what was the initial pressure in the container prior to decomposition?

c). for the following reaction, find the value of q and predict the direction of change, given that a 1l flask initially contains 2 moles s8, 2 moles sf6, and 2 moles f2.

1/8 s8 (s) + 3 f2 (g) ? sf6 (g) kc = 0.425

d)

a key step in the extraction of iron from its ore is

feo(s) + co(g) ? fe(s) + co2(g) kp =0.403 at 1000°c.

what are the equilibrium partial pressures off carbon monoxide and carbon dioxide when 1.00 atm of carbon monoxide and excess iron(ii) oxide react in a sealed container at 1000°c.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
You know the right answer?
Asealed container initially contains only 1.0 m gas a and 1.0 m gas b. upon heating the following re...
Questions
question
Mathematics, 01.10.2019 10:10
question
World Languages, 01.10.2019 10:10
question
History, 01.10.2019 10:10
question
Geography, 01.10.2019 10:10
question
Mathematics, 01.10.2019 10:10
Questions on the website: 13722360