subject
Engineering, 23.01.2020 05:31 Theresab2021

Astudent team is to design a human-powered submarine for a design competition. the overall length of the prototype submarine is 4.85 m, and its student designers hope that it can travel fully submerged through water at 0.440 m/s. the water is freshwater (a lake) at t = 15 °c. the design team builds a one-fifth scale model to test in their university’s wind tunnel. a shield surrounds the drag balance strut so that the aerodynamic drag of the strut itself does not influence the measured drag. the air in the wind tunnel is at 25°c and at one standard atmosphere pressure. the students measure the aerodynamic drag on their model submarine in the wind tunnel. they are careful to run the wind tunnel at conditions that ensure similarity with the prototype submarine. their measured drag force is 5.75 n. "estimate the drag force" on the prototype submarine at the given conditions.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apipe with an outside diameter of 15 cm is exposed to an ambient air and surrounding temperature of -20°c. the pipe has an outer surface temperature of 65°c and an emissivity of 0.85. if the rate of heat loss from the pipe surface is 0.95 kw per meter of length, the external convective heat transfer coefficient (h) is: (a) 12.5 w/m"k (b) 18.6 w/mk (c) 23.7 w/mk (d) 27.9 w/mk (e) 33.5 w/mk
Answers: 1
question
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
question
Engineering, 04.07.2019 18:10
Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.
Answers: 1
You know the right answer?
Astudent team is to design a human-powered submarine for a design competition. the overall length of...
Questions
question
Mathematics, 09.03.2021 20:50
question
Mathematics, 09.03.2021 20:50
question
Mathematics, 09.03.2021 20:50
question
Mathematics, 09.03.2021 20:50
question
Mathematics, 09.03.2021 20:50
question
Physics, 09.03.2021 20:50
Questions on the website: 13722361