Engineering, 29.01.2020 05:40 jumpman2344

An insulated open feedwater heater (mixing box) is used in a steam power plant to raise the temperature of the water going into the boiler which increases the thermal efficiency. the water exits the feedwater heater as a saturated liquid at p6 with a mass flow rate of m6. the two inlets to the feedwater heater are both at a pressure of p6. the first inlet has a temperature of t3 and second at a temperature of t5. determine the following given the properties listed below.
--given values--

p6 (bar) = 5
m6 (kg/s) = 72
t3 (c) = 281
t5 (c) = 65

1. determine the specific enthalpy (kj/kg) at the feedwater heater exit.
your answer =
2. determine h3, the specific enthalpy (kj/kg) at the first feedwater heater inlet.
your answer =
3. determine h5, the specific enthalpy (kj/kg) at the second feedwater heater inlet.
your answer =
4. determine m3, the mass flow rate (kg/s) at the first feedwater heater inlet.
your answer =
5. determine m5, the mass flow rate (kg/s) at the second feedwater heater inlet.
your answer =

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

You know the right answer?

An insulated open feedwater heater (mixing box) is used in a steam power plant to raise the temperat...

Questions