subject
Engineering, 05.02.2020 21:50 ICAMARON5070

Awell-insulated rigid tank is divided into two regions by a movable partition through which heat can flow via conduction. in the left region air exists with the following properties (2 kg, 5 bar, 350 k). in the right region co exists with the following properties (4 kg, 2 bar, 450 k). a pin holds the partition in place. the pin is removed and the air and co achieve pressure and temperature equilibrium. use a control volume that includes the air, the co and the partition. neglect the mass of the partition. a. assume constant specific heat for both air and co. look up the necessary specific heat values at an estimated average temperature of 400 k. b. determine the final temperature. c. using a new, more accurate, average air temperature and a new, more accurate, average co temperature, estimate how far off, in percent, the original specific heat estimates at 400 k are.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
Awell-insulated rigid tank is divided into two regions by a movable partition through which heat can...
Questions
Questions on the website: 13722359