Engineering, 11.02.2020 00:18 juanaaraujo1104

1. A) For a steel specimen, the stress at which plastic deformation begins is 400 MPa, and the modulus of elasticity is 207 GPa. (a)What is the maximum load that may be applied to a specimen with diameter of 8.5 mm without plastic deformation? (b) If the original specimen length is 80 mm, what is the maximum length to which it may be stretched without causing plastic deformation?

B) A cylindrical specimen of a "Panther-alloy" is stressed in compression. If its original and final diameters are 10.000 and 10.025 mm, respectively, and its final length is 52.96 mm, compute its original length if the deformation is totally elastic. The elastic and shear moduli for this alloy are 105 GPa and 39.7 GPa, respectively.

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

1. A) For a steel specimen, the stress at which plastic deformation begins is 400 MPa, and the modul...

Questions