Engineering, 11.02.2020 20:59 SushiMagic
Consider the ionic salt, KCl (potassium chloride). The attractive and repulsive energies between the ions K+ and Cl depend on the distance r between them according to the following relationships:
Er=5.86x10-6/r^9
Ea = -1.436/r
En = EA +ER
where the energies are expressed in electron volts (eV) and the distance r is in nanometers (10°m). Eis the net potential energy between the ions.
(a) Using Excel, superimpose on a single plot EN, ER, and EA versus r, for r from 0.22nm to 0.5nm. Build the spreadsheet first and then plot the functions. Hint: Use a fine enough interval between r values such that you can see a minimum EN value.
(b) On the basis of this plot, determine (i) the equilibrium spacing r0 between the K+ and Cl– ions, and (ii) the magnitude of the bonding energy E0 between the two ions.
(c) Mathematically determine the r0 and E0values using the equations above and compare these with the graphical results from part (b)
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery
Answers: 2
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
Consider the ionic salt, KCl (potassium chloride). The attractive and repulsive energies between the...
Questions
Biology, 16.10.2019 05:00
English, 16.10.2019 05:00
Health, 16.10.2019 05:10
Mathematics, 16.10.2019 05:10
Computers and Technology, 16.10.2019 05:10
Computers and Technology, 16.10.2019 05:10
