subject
Engineering, 13.02.2020 17:51 alegora78

The actual distance between two marks used at a university for standardizing tapes is 100.03 ft. When a certain tape was held along this line, the surveyor, thinking that the distance between the marks was 100.00 ft, observed the tape was 99.94 ft long. What is correct length of the tape?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines
Answers: 1
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
question
Engineering, 04.07.2019 18:20
An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.
Answers: 3
You know the right answer?
The actual distance between two marks used at a university for standardizing tapes is 100.03 ft. Whe...
Questions
question
Mathematics, 08.01.2021 16:50
question
Mathematics, 08.01.2021 16:50
question
Mathematics, 08.01.2021 16:50
question
Chemistry, 08.01.2021 16:50
question
Mathematics, 08.01.2021 16:50
Questions on the website: 13722360