Engineering, 14.02.2020 19:01 patriciamelton57
The homogeneous decomposition of the free-radical polymerization initiator diethyl peroxydicarbonate (DEPDC) has been studied in supercritical carbon dioxide using and ideal CSTR. The concentration of DEPDC in the feed to the CSTR was 0.3 mM. Because of this very low concentration, constant fluid density can be assumed. At 70 °C and a space time of 10 min, the fractional conversion of DEPDC was 0.21. At 70 °C and a space time of 30 min, the fractional conversion of DEPDC was 0.44.
The rate equation for the DEPDC decomposition is believed to have the form:
rDEPDC=k[DEPDC]n
What is the value of n, and what is the value of k at 70 °C?
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
You know the right answer?
The homogeneous decomposition of the free-radical polymerization initiator diethyl peroxydicarbonate...
Questions
Mathematics, 25.05.2021 19:00
Mathematics, 25.05.2021 19:00
Mathematics, 25.05.2021 19:00
Mathematics, 25.05.2021 19:00
Mathematics, 25.05.2021 19:00
History, 25.05.2021 19:00
English, 25.05.2021 19:00
Physics, 25.05.2021 19:00
Chemistry, 25.05.2021 19:00
Chemistry, 25.05.2021 19:00
