subject
Engineering, 16.02.2020 08:32 nails4life324

Module 42 Review and Assessment
Summing Up the Key Ideas: Match the following terms to the correc
A. Inflation
D. Consumer price index G. Producer price
B. Inflation rate
I. Shoe leather costs
E. Market basket
index
J. Menu costs
C. Deflation F. Base period
H. Hyperinflation
1. A decrease in the price level.
2. A measure of the overall price level faced by a typical consumer.
3. The costs of updating prices due to inflation.
4. A bundle of goods that an average consumer might buy.
5. The annual percentage increase in the price level.
6. A period of very rapid inflation
7. A rise in the price level.
8. A period in the past used as a benchmark for comparisons.
9. A measure of the cost of a basket of goods and services bought by producers.
10. The costs of time and effort involved in frequent trips to the bank or ATM to avoid
holding much cash during periods of high inflation.
Analyze and Explain: Determine if the person described in each of the following situations
would be helped by inflation or hurt by inflation and then explain your answer.
HELPED OR HURT?
EXPLANATION
1. a retired worker with a fixed pension
during a time of inflation
2. a lending bank that expocted the
inflation rate to be 7 percent when the
actual rate of indiation for the duration
of the lon turned oun to be 4 percent
I need that

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
question
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
question
Engineering, 04.07.2019 18:20
Inspection for bearing condition will include: (clo4) a)-color b)-smell c)-size d)-none of the above
Answers: 1
question
Engineering, 04.07.2019 18:20
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
You know the right answer?
Module 42 Review and Assessment
Summing Up the Key Ideas: Match the following terms to the cor...
Questions
question
English, 02.07.2019 13:30
question
Biology, 02.07.2019 13:30
question
Mathematics, 02.07.2019 13:30
question
English, 02.07.2019 13:30
Questions on the website: 13722367