Engineering, 18.02.2020 03:40 idkjules5728

Two large, nonconducting plates are suspended 8.25 cm apart. Plate 1 has an area charge density of + 86.8 μC/m2 , and plate 2 has an area charge density of + 23.6 μC/m2 . Treat each plate as an infinite sheet. Two parallel vertical lines are horizontally separated from each other. Each line represents a nonconducting plate. The plate on the left is labeled plate 1, and the plate on the right is labeled plate 2. The region of space to the left of plate 1 is labeled region A. The region of space between the two plates is labeled region B. The region to the right of plate 2 is labeled region C. How much electrostatic energy U E is stored in 2.29 cm3 of the space in region A?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

You know the right answer?

Two large, nonconducting plates are suspended 8.25 cm apart. Plate 1 has an area charge density of +...

Questions