Engineering, 18.02.2020 18:03 mjessen119

This elementary problem begins to explore propagation delayand transmission delay, two central concepts in data networking. Consider two hosts A andB, connected by a single link of rate R bps. suppose that the two hosts are separated by mmeters, and supose the propagation speed along the link is s meters/sec. Host A is to send a packet ofsize L bits to Host B. a. Express the propagation delay d(prop) interms of L and R. b. Determine the trnasmission time of the packet d(trans) in termsof L and R. c. Ignoring processing and queing delays obtain an expression forthe end to end delay. d. Supose Host A begins to transmit packet at time t=0 . At timet=d(trans) where is the last bit of the packet. e. Suppose d(prop)is greater than d(trans) . At time t= d(trans)where is the first bit of the packetf. Suppose d(prop)is less than d(trans) . At time t= d(trans) whereis the first bit of the packetg. Suppose s=2.5* 10power(8), L=100 bits and R=28 kbps. find thedistance m so tha d(prop) equals d(trans).

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

This elementary problem begins to explore propagation delayand transmission delay, two central conce...

Questions