Engineering, 19.02.2020 00:24 pino40

For problems 1-8 please solve for u (specific internal energy) and h (specific enthalpy), for water (H2O), given the following information. You can check your answers using online quiz HW6e2.1. H20, T = 230°C, P = 5000 kPa 2. H20, T = 200°C, P = 1000 kPa 3. H20, T = 120°C, ʋ = 0.5000 m3/kg 4. H20, P = 600 kPa, ʋ = 0.5000 m3/kg 5. H20, P = 2 kPa, saturated vapor 6. H20, T = 300°C, saturated liquid 7. H20, P = 6000 kPa, x = 0.170 8. H20, T = 330°C, x = 0.850

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 19:30

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

You know the right answer?

For problems 1-8 please solve for u (specific internal energy) and h (specific enthalpy), for water...

Questions