Engineering, 21.02.2020 04:34 kylaprather06

A gear and shaft with nominal diameter of 34 mm are to be assembled with a medium drive fit (H7/s6). The gear has a hub, with an outside diameter of 45 mm, and an overall length of 50 mm. The shaft is made from AISI 1020 CD steel, and the gear is made from steel that has been through hardened to provide Su = 700 MPa and Sy = 600 MPa. a) Specify dimensions with tolerances for the shaft and gear bore to achieve the desired fit. b) Determine the minimum and maximum pressures that could be experienced at the interfaces with the specified tolerances. c) Determine the worst-case static factors of safety guarding against yielding at assembly for the shaft and the gear based on Von-Mises failure theory. d) Determine the maximum torque that the joint should be expected to transmit without slipping.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

Answer

You know the right answer?

A gear and shaft with nominal diameter of 34 mm are to be assembled with a medium drive fit (H7/s6)....

Questions